#ARDUINO MEGA TO ATMEGA2560 PINOUT SERIAL#

In future, shields will be compatible both with the board that use the AVR, which operate with 5V and with the Arduino Due that operate with 3.3V. 1.0 pinout: added SDA and SCL pins that are near to the AREF pin and two other new pins placed near to the RESET pin, the IOREF that allow the shields to adapt to the voltage provided from the board.Revision 3 of the board has the following new features: Revision 2 of the Mega2560 board has a resistor pulling the 8U2 HWB line to ground, making it easier to put into DFU mode. As long as you select the correct 'serial port' the ATmega2560 should work just like an Arduino Mega 2560.

#ARDUINO MEGA TO ATMEGA2560 PINOUT SERIAL#

They both show up to tha IDE software as serial ports. Instead, it features the ATmega16U2 (ATmega8U2 in the revision 1 and revision 2 boards) programmed as a USB-to-serial converter. The FTDI and 16U are both acting as USB to TTL Serial adapters. The Mega2560 differs from all preceding boards in that it does not use the FTDI USB-to-serial driver chip. The Mega 2560 is an update to the Arduino Mega, which it replaces. The Mega is compatible with most shields designed for the Arduino Duemilanove or Diecimila. It contains everything needed to support the microcontroller simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started. It has 54 digital input/output pins (of which 15 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. The Arduino Mega 2560 is a microcontroller board based on the ATmega2560.

Arduino mega to atmega2560 pinout